Skip to main content

Research Repository

Advanced Search

Experimental study of dense pyroclastic density currents using sustained, gas-fluidized granular flows

Rowley, Pete J.; Roche, Olivier; Druitt, Timothy H.; Cas, Ray

Experimental study of dense pyroclastic density currents using sustained, gas-fluidized granular flows Thumbnail


Authors

Dr Peter Rowley Peter.Rowley@uwe.ac.uk
Senior Lecturer in Physical Geography/Earth Science/ Geology

Olivier Roche

Timothy H. Druitt

Ray Cas



Abstract

© 2014, Springer-Verlag Berlin Heidelberg. We present the results of laboratory experiments on the behaviour of sustained, dense granular flows in a horizontal flume, in which high-gas pore pressure was maintained throughout the flow duration by continuous injection of gas through the flume base. The flows were fed by a sustained (0.5–30 s) supply of fine (75 ± 15 μm) particles from a hopper; the falling particles impacted an impingement surface at concentrations of ~3 to 45 %, where they densified rapidly to generate horizontally moving, dense granular flows. When the gas supplied through the flume base was below the minimum fluidization velocity of the particles (i.e. aerated flow conditions), three flow phases were identified: (i) an initial dilute spray of particles travelling at 1–2 m s−1, followed by (ii) a dense granular flow travelling at 0.5–1 m s−1, then by (iii) sustained aggradation of the deposit by a prolonged succession of thin flow pulses. The maximum runout of the phase 2 flow was linearly dependent on the initial mass flux, and the frontal velocity had a square-root dependence on mass flux. The frontal propagation speed during phase 3 had a linear relationship with mass flux. The total mass of particles released had no significant control on either flow velocity or runout in any of the phases. High-frequency flow unsteadiness during phase 3 generated deposit architectures with progradational and retrogradational packages and multiple internal erosive contacts. When the gas supplied through the flume base was equal to the minimum fluidization velocity of the particles (i.e. fluidized flow conditions), the flows remained within phase 2 for their entire runout, no deposit formed and the particles ran off the end of the flume. Sustained granular flows differ significantly from instantaneous flows generated by lock-exchange mechanisms, in that the sustained flows generate (by prolonged progressive aggradation) deposits that are much thicker than the flowing layer of particles at any given moment. The experiments offer a first attempt to investigate the physics of the sustained pyroclastic flows that generate thick, voluminous ignimbrites.

Citation

Rowley, P. J., Roche, O., Druitt, T. H., & Cas, R. (2014). Experimental study of dense pyroclastic density currents using sustained, gas-fluidized granular flows. Bulletin of Volcanology, 76(9), 1-13. https://doi.org/10.1007/s00445-014-0855-1

Journal Article Type Article
Acceptance Date Aug 2, 2014
Online Publication Date Aug 17, 2014
Publication Date Jan 1, 2014
Deposit Date Jul 8, 2019
Publicly Available Date Jul 8, 2019
Journal Bulletin of Volcanology
Print ISSN 0258-8900
Electronic ISSN 1432-0819
Publisher Springer (part of Springer Nature)
Peer Reviewed Peer Reviewed
Volume 76
Issue 9
Pages 1-13
DOI https://doi.org/10.1007/s00445-014-0855-1
Keywords experimental modelling, volcanology, sedimentology, fluidisation, bedform development, granular flow, pyroclastic density currents
Public URL https://uwe-repository.worktribe.com/output/1494682
Publisher URL http://doi.org/10.1007/s00445-014-0855-1
Additional Information Additional Information : The final publication is available at Springer via https://doi.org/10.1007/s00445-014-0855-1

Files




You might also like



Downloadable Citations