Outputs (10)

Control of PEM fuel cell system via higher order sliding mode control (2012)
Journal Article

This paper presents a multi-input multi-output (MIMO) dynamic model of polymer electrolyte membrane (PEM) fuel cells. A non-linear controller is designed to prolong the stack life of the PEM fuel cell. A moderate deviation between hydrogen and oxygen... Read More about Control of PEM fuel cell system via higher order sliding mode control.

Novel bio-inspired approach for fault-tolerant VLSI systems (2012)
Journal Article

Living organisms are complex systems, and yet they possess extremely high degrees of reliability. Since failures are local, their repair will often be taken on the local (cell) level. Engineers have long sought systems that could offer similar reliab... Read More about Novel bio-inspired approach for fault-tolerant VLSI systems.

Prolong the stack life of PEM fuel cell system via higher order sliding mode control (2012)
Presentation / Conference Contribution

Fuel cells are electrochemical generators where produce electrical energy from chemical reactants. It is why these are good candidates to provide clean energy generation. This paper presents a multi-input multi-output (MIMO) dynamic model of polymer... Read More about Prolong the stack life of PEM fuel cell system via higher order sliding mode control.

An automated method for costing flood risk mitigation measures for use with flood risk management decision support systems (2012)
Presentation / Conference Contribution

An initial study of the effect of using liquid nitrogen coolant on the surface roughness of inconel 718 nickel-based alloy in CNC milling (2012)
Presentation / Conference Contribution

The most used alloy of nickel, Inconel 718 is known to difficult to machine owing to its superior material and physical properties. This paper presents one of the very first studies on cryogenic CNC end milling of the Inconel 718 nickel based alloy u... Read More about An initial study of the effect of using liquid nitrogen coolant on the surface roughness of inconel 718 nickel-based alloy in CNC milling.

Change risk assessment for Scotland (2012)
Report

The UK Climate Change Risk Assessment (CCRA) for Scotland was one of three devolved administration reports produced by the UK Government as part of the first ever UK Climate Change Risk Assessment (CCRA1). This report identified specific threats as... Read More about Change risk assessment for Scotland.

The UK’s first climate change risk assessment and the implications for the coast (2012)
Presentation / Conference Contribution

In 2008 the Climate Change Act was passed into law in the UK. This provides a legally binding framework for reducing carbon emissions. Much of the focus of the Act is on reducing emissions and hence on mitigation measures, however, the Act also req... Read More about The UK’s first climate change risk assessment and the implications for the coast.

UK climate change risk assessment: Government report 2012 (2012)
Report

Climate change risk assessment for the health sector (2012)
Report

The UK Climate Change Risk Assessment (CCRA) for the Health Sector was one of 12 sector reports published by the Government on 25 January 2012. It was part of the first ever UK Climate Change Risk Assessment (CCRA1), with the key results of this repo... Read More about Climate change risk assessment for the health sector.

UK climate change risk assessment: Evidence report (2012)
Report

The UK Climate Change Risk Assessment (CCRA) Evidence Report was published by the Government on 25 January 2012. It was the first ever UK Climate Change Risk Assessment (CCRA1), which are published on a 5-yealry cycle, a requirement of the 2008 Clima... Read More about UK climate change risk assessment: Evidence report.