All Outputs (4)

An explorative study on the antimicrobial effects and mechanical properties of 3D printed PLA and TPU surfaces loaded with Ag and Cu against nosocomial and foodborne pathogens (2022)
Journal Article
Εkonomou, S. Ι., Soe, S., & Stratakos, A. C. (2023). An explorative study on the antimicrobial effects and mechanical properties of 3D printed PLA and TPU surfaces loaded with Ag and Cu against nosocomial and foodborne pathogens. Journal of the Mechanical Behavior of Biomedical Materials, 137, 105536. https://doi.org/10.1016/j.jmbbm.2022.105536

Antimicrobial 3D printed surfaces made of PLA and TPU polymers loaded with copper (Cu), and silver (Ag) nanoparticles (NPs) were developed via fused deposition modeling (FDM). The potential antimicrobial effect of the 3D printed surfaces against Esch... Read More about An explorative study on the antimicrobial effects and mechanical properties of 3D printed PLA and TPU surfaces loaded with Ag and Cu against nosocomial and foodborne pathogens.

Laser powder bed fusion of TiB2-modified Cu15Ni8Sn alloy: Processability, microstructure and mechanical performance (2022)
Journal Article
Gao, J., Han, Q., Wang, L., Liu, Z., Soe, S., Zhang, Z., & Gu, Y. (2022). Laser powder bed fusion of TiB2-modified Cu15Ni8Sn alloy: Processability, microstructure and mechanical performance. Materials Science and Engineering: A, 855, 143879. https://doi.org/10.1016/j.msea.2022.143879

Cu15Ni8Sn is widely used in the aerospace and electronics domains because of its good conductivity and toughness. Due to the material's high laser reflectivity and thermal conductivity, however, employing the laser powder bed fusion (LPBF) additive m... Read More about Laser powder bed fusion of TiB2-modified Cu15Ni8Sn alloy: Processability, microstructure and mechanical performance.

Response of gyroid lattice structures to impact loads (2022)
Journal Article
Ramos, H., Santiago, R., Soe, S., Theobald, P., & Alves, M. (2022). Response of gyroid lattice structures to impact loads. International Journal of Impact Engineering, 164, Article 104202. https://doi.org/10.1016/j.ijimpeng.2022.104202

This paper reports on a comprehensive investigation of gyroid lattice structures subject to impact loading. AlSi10Mg samples were manufactured using selective laser melting (SLM) and mechanically characterized using Digital Image Correlation (DIC). U... Read More about Response of gyroid lattice structures to impact loads.

Mechanical behaviour of additively manufactured elastomeric pre-buckled honeycombs under quasi-static and impact loading (2022)
Journal Article
Adams, R., Townsend, S., Soe, S., & Theobald, P. (2022). Mechanical behaviour of additively manufactured elastomeric pre-buckled honeycombs under quasi-static and impact loading. Materials and Design, 213, Article 110368. https://doi.org/10.1016/j.matdes.2021.110368

Selective laser sintering has been used to manufacture different structural variations of a pre-buckled circular honeycomb. The mechanical behaviour of these structures has been examined under both quasi-static and dynamic impact loading. Pre-buckled... Read More about Mechanical behaviour of additively manufactured elastomeric pre-buckled honeycombs under quasi-static and impact loading.